Jerry Payton wrote:
Neil, I still believe it would be more intuitive if the program were consistent in providing a RMB --> "Edit in iPropWiz" context sensitive menu entry both in the Assembly environment and the Drawing manager.
In this way the user doesn't have to be trained to "do this when you're in a drawing, but when you're in an assembly, do this instead."
Further to this - in regards to the selection workflow - it would be beneficial if ipropwiz could conform to the selection made in the browser or graphics area, be it:
- a part, selected via "Part Priority"
- a component (presumably a part or assembly), selected via "Component Priority"
- any combination of parts or assemblies selected by the user.
As is, selecting "Single Select" in the current interface, forces the user to a "Part Select" mode, and so they cannot select a subassembly. In other words, the Single Select mode - while providing a way to edit a part's property (one part at a time) - is limited in functionality and, IMHO could be replaced with a more intuitive workflow of selecting a set, then RMB --> Edit in IPROPWIZ.
I understand the intent of "Single Select".