It is currently Fri May 24, 2013 4:59 pm

View unanswered posts | View active topics


Board index » Other CAD Discussion » SolidWorks Discussion

All times are UTC





Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 
  Print view Previous topic | Next topic 
Author Message
Jim
 Post subject: Curving a logo (or text)
PostPosted: Wed Dec 13, 2006 5:07 pm 
Offline
MCAD Lurker

Joined: 21 Aug 2006
Posts: 8
What I am trying to do is curve a logo to make it in the form of a shield. For instance if I were to take the Nike swoosh which is flat on a plane and wanted to curve it in a shield form. I've tried sheetmetal tools, but I'm not even sure that this is the direction to take. Any suggestions?


Share on FacebookShare on TwitterShare on DiggShare on DeliciousShare on TumblrShare on Google+
Top
 Profile  
 
Pineapple
 Post subject:
PostPosted: Wed Dec 13, 2006 7:15 pm 
Offline
MCAD Expert

Joined: 11 Apr 2006
Posts: 1550
Country: Canada
State: Ontario
CAD System: Inventor
Warp.
Top
 Profile  
 
doyle808
 Post subject:
PostPosted: Mon Dec 18, 2006 3:13 pm 
Offline
MCAD Contributer

Joined: 19 Aug 2004
Posts: 52
Hi Jim,
You could also try extruding up to surface, and using an offset surface to trim the bottom.

Is the attachment close to what you are lookng for?


You do not have the required permissions to view the files attached to this post. You must LOGIN or REGISTER to view these files.

_________________
Richard Doyle
SolidWorks User Group Network
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 

Board index » Other CAD Discussion » SolidWorks Discussion

All times are UTC


Who is online

Users browsing this forum: No registered users and 2 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
POWERED_BY